GRP2: Group 2

The GRP2 module contains three samplers that can be sequenced with SEQ2. 2-1 and 2-2 share the C key, so it turns both on or off together. Right-click an instrument to make it follow another trigger. See also Trigger Source.

Parameter	Description
PRESET	Stores and recalls the settings of all three instruments. See also Preset Selector.
MUTE GRP	When on, an instrument that plays cuts off the others in this group that share a BUS1-BUS3 or FX1-FX3 output. See also Mute.

---

2-1 : Sampler

Parameter	Description
C (Activator Switch)	Turns this instrument on or off. The C key does the same by default.
FILE MENU	Selects the sound file. See also Sound File Menu.
CV	Chance that the trigger reaches the FX, the sends, the mixer, and the trigger outputs. See also Trigger Events (CV).
BUS	Where the sound goes, in any combination. SEND enables the DL1, DL2, and RVB dials. See also Audio Bus.
PAD	The small button at the end of the BUS row. Click it to play the instrument once.
ENVELOPE	Sets the volume and pitch envelopes. See also Envelope.
PCH	Tunes the sound smoothly, up to 3 octaves up or down (1.00 = original pitch).
TRP	Transposes the sound in semitones, from -36 to +36. Adds to PCH and to the TRP module.
REV	Sets the chance that a hit plays in reverse.
VOICE	Sets how many hits can sound at once, from 1 to 8. A new hit beyond that cuts off the oldest.
LFO MENU	Shows the LFO’s shape and targets. Click to open the LFO panel. Targets: PCH, DRV, RM, FRQ, HPF, LPF, RES, BIT, SMP, OVT, DL1, DL2, RVB, PAN, LEV. See also LFO.
DRV	Randomizable Adjusts the amount of overdrive.
RM	Randomizable Adjusts the amount of ring modulation.
FRQ	Randomizable Adjusts the frequency of ring modulation.
HPF	Randomizable Adjusts the cutoff frequency of the high-pass filter.
LPF	Randomizable Adjusts the cutoff frequency of the low-pass filter.
RES	Randomizable Adjusts the resonance amount of the high-pass and low-pass filter.
LFO	Randomizable Adjusts the frequency of the LFO.
AMT	Randomizable Adjusts the amount of LFO modulation.
BIT	Randomizable Adjusts the bit depth. Lower values produce a lo-fi sound.
SMP	Randomizable Adjusts the sample rate.
OVT	Randomizable Adjusts the wave folder, which adds overtones.
DL1	Randomizable Adjusts the send level to DL1.
DL2	Randomizable Adjusts the send level to DL2.
RVB	Randomizable Adjusts the send level to RVB.
PAN	Randomizable Adjusts the panning.
LEV	Randomizable Adjusts the output level.

---

2-2 : Sampler

The controls are the same as 2-1, with one difference: 2-2 runs the crusher (BIT, SMP, OVT) before the filters (HPF, LPF, RES), so those two sets of dials swap rows.

---

2-3 : Sampler

The controls are the same as 2-2. The V key turns it on or off by default.

---